Kawasaki Ninja 1000 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello everyone new member here!
I have installed the Denali D4s on my 17 ninja. But to make them work they have to be attached via posi tap. According to Denali you shouldn't use lights since they are LEDs. I have an Aux outlet and heated grips. What positive wire should I tap into so that they only draw power when the bike is on?
28894
 

·
Premium Member
Joined
·
1,691 Posts
I don't know what they draw but the built in grip heater circuit is 15A. The pigtails are on the left side wiring harness. Given the grip heaters only draw ~3A you should be good to go. It's the blue-red wire with the bullet connector on the left side wiring harness. The black-yellow is the ground.
 
  • Like
Reactions: Minxmou

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
They are attached to the R-Gaza crash bars. Then the wires are routed through the inside of the frame to the battery under the seat. We routed the switch under the tank to the left handle bar.
28921
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top