Kawasaki Ninja 1000 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
93 Posts
1000 Gorillas tightened the front sprocket nut on my 2006 ZZR600. Could not get it to move with a 1/2 inch impact wrench when I did a 520 sprocket and chain conversion. Trailered it over to my local Kawi dealer. They rolled it in the shop and put it up on the stand table. The tech took a impact wrench and bam 2 seconds later the nut was off the bike. Best part of the story is they didn't even charge me. The nut was on the bike at 94 ft./lbs. of torque according to the service manual. More like 940 ft./lbs.!!!!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top