Kawasaki Ninja 1000 Forum banner

Custom Dynamics Magic Strobe installation help

2K views 4 replies 2 participants last post by  Night Train 
#1 ·
Hello all, I have a 2019 N1K and purchased the Custom Dynamics Brake modulator. It's a simple installation that requires cutting the wire to the brake light, splicing one end to one wire from the modulator and the same with the other end and ground.

I'm looking for a place on the bike to get to the correct wire without having to do a lot of dismantling.

Does anyone have any suggestions of where to install or have done the same modification?

Thank you ahead of time.
 
#2 ·
Haven't done that mod but it's quite easy to get to the brake wire in the tail piece. I just pulled it apart to add some auxiliary brake lights. I've included a portion of the schematic and the service manual page. Hope this helps.
 

Attachments

#4 ·
Pretty much. Loosen 4, remove 2 and it slides out. You'll see the wiring to tap into. Just choose the correctly colored wire(s).
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top